A robust and adaptable base for mounting full hydro steering.

The 4Krawl Products universal hydraulic steering ram mount is designed to facilitate the installation of a steering ram on a 4x4, buggy, or Off-Road prototype axle.

Made from 6 mm thick S235 steel, it is delivered raw and must be welded directly to the axle or to a suitable reinforcement structure.

Its universal design allows the positioning of the ram to be adapted according to the axle and steering geometry, with a maximum ram mounting width of 370 mm.

➡️ A simple, robust, and easily adaptable solution for a clean custom installation of a hydraulic steering system.

Universal design

The 4Krawl Products mount is not specific to any one vehicle or axle model.

It serves as a universal fabrication base, allowing the builder to precisely adapt the ram position to their setup.

This design is particularly beneficial for:

✔ Built 4x4s
✔ Prototypes
✔ Buggies
✔ Rock Crawlers
✔ Ultra4
✔ Competition vehicles
✔ Full Hydro steering conversions

Similar to the TMR mount principle, the final positioning depends on the axle configuration and allows the ram to be installed in the area best suited to the vehicle's geometry.

Up to 370 mm mounting width

The mount accepts a:

Maximum ram mounting width: 370 mm

This dimension corresponds to the maximum distance available for integrating the ram onto the mount.

The final position must be determined during assembly based on:

• The ram used
• Its travel
• The width between its mounting points
• The steering geometry
• The position of the steering arms
• Axle articulation
• The space available around the differential and axle

➡️ The mount can be adjusted and positioned during fabrication to adapt to the vehicle's configuration.

6 mm S235 Steel

The mount is made of:

S235 Steel – 6 mm thickness

This construction provides a robust base to handle the stresses generated by a hydraulic steering ram.

Developed for Off-Road builds

This type of mount is specifically intended for vehicles where the steering and axle have been heavily modified.

It acts as a fabrication base allowing for a custom installation rather than imposing a fixed position for the ram.

Professional installation recommended

As the mount is universal and weld-on, its installation requires precisely checking the steering geometry before final welding.

It is particularly essential to verify operation over the full range of steering travel and suspension articulation to avoid any mechanical binding or incorrect ram bottoming out.

Contents

• 1 4Krawl Products universal hydraulic steering ram mount